Pipe Saddles, Insulation & Shields

Showing all 6 results

Self Centering Insulation Shield

Figure: 160


Designed to provide maximum protection to the insulation. The centering ribs are spaced to center the hanger on the shield, providing equal load distribution. The shield is furnished with flared ends to prevent it from cutting into the insulation.

Snappitz Self-Locking Pipe & Tube Insulation

Figure: 165 & 166


Designed for the insulation of iron pipe (Fig. 165) or copper tube (Fig. 166). The one piece self-locking design allows for easier and faster installation and eliminates the need for a separate shield.

Snappitz Non-Locking Insulation

Figure: 167 & 168


Designed for the insulation of iron pipe (Fig. 167) or copper tube (Fig. 168). The two piece non-locking design eliminates the need for a separate shield.

Insulation Protection Shield

Figure: 170


Designed for use in the suspension of insulated pipe lines to protect the insulation from being crushed by the hanger.

Pipe Saddles For 1″, 1-1/2″, 2′, 2-1/2″, 3″ & 4″ Insulation

Figure: 651 - 658


Designed to protect insulation on high temperature pipe lines. The saddle is furnished with notches to minimize surface contact with the pipe, thereby keeping heat loss to a minimum.

Selection Guide

Figure: 145, 155, 160, 170, & 455


Designed to serve as a guide for determining the proper insulation protection shield for standard pipe or tube sizes and insulation thicknesses.