Center Load Clamps
Showing all 6 results
Standard Duty Center Load Beam Clamp
Figure: 610
Function
Designed to be used in the suspension of a hanger rod from the center of an I-beam. The clamp’s design allows the load to be distributed equally on either side of the beam. Normally used in conjunction with Fig. 50 eye rod, Fig. 55 welded eye rod, or Fig. 35 weldless eye nut.
Heavy Duty Center Load Beam Clamp
Figure: 620
Function
Designed to be used in the suspension of a hanger rod from the center of an I-beam. The clamp’s design allows the load to be distributed equally on either side of the beam. Normally used in conjunction with Fig. 55 welded eye rod or Fig. 35 weldless eye nut.
Steel Center Load Beam Clamp
Figure: 625
Function
Designed to be used in the suspension of a hanger rod from the center of an I-beam. The clamp provides a vertical adjustment of approximately 2″ (50.8).
Malleable Iron Center Load Beam Clamp
Figure: 630
Function
Designed to be used in the suspension of a hanger rod from the center of an I-beam. The clamp’s design allows the load to be distributed equally on either side of the beam. The clamp is adjustable from 23/8” (60.33) to 7″ (177.8) and can be used with flange thicknesses up to .60 inches (15.24). Normally used in conjunction with Fig. 25 extension piece. An additional 1″ (25.4) or more of vertical adjustment is obtained when used with Fig 25.
Steel Center Load Beam Clamp
Figure: 632 & 633
Function
Designed to be used in the suspension of a hanger rod from the center of an I-beam. The clamp’s design allows the load to be distributed equally on either side of the beam. The clamp is adjustable and normally used in conjunction with Fig. 35 weldless eye nut. An additional 1″ (25.4) or more of vertical adjustment is obtained when used with Fig 35.
Adjustable Steel Beam Clamp
Figure: 635
Function
Designed to be used in the suspension of a hanger rod from an I-Beam. The clamp is adjustable from 31⁄2” (88.9) to 8” (203.2) and can be used with flange thicknesses up to 1/2” (12.7).