Search Results: “” – Page 27

Ceiling Flanges

Figure: 940, 941, & 942

Function

Designed to provide a means for attaching hanger rod to wood beams or ceilings.

Hex Head Bolt

Figure: 41

Function

Designed for use as a fastening device.

Pipe Roller Selection Guide

Figure: 460, 470, 475, 480, 480D, 485, 486, 487, 488, 490,, 495, & 496

Function

Designed to serve as a guide for determining the proper pipe roller support size for standard pipe sizes and insulation thicknesses.

Short Pipe Strap

Figure: 830

Function

Designed to hold pipe flush with mounting surface.

Lag Screw

Figure: 45

Function

Designed for use as a fastening device to wood structures.

One Hole Strap

Figure: 835 - 837

Function

Designed for the support of standard steel pipe (Fig. 835), copper tube (Fig. 836), or EMT conduit (Fig. 837) on walls or sides of beams. Not recommended for use horizontally, on ceilings, or bottoms of beams.

Steel Ceiling Plate

Figure: 945 & 946

Function

Designed to provide a means for attaching hanger rod to wood beams or ceilings. The copper finish is for product identification only and is not intended for corrosion resistance.

Concrete Anchors

Figure: 47D, 47S, & 47W

Function

47D: Designed to function as a drill, drilling its own hole and as an anchor. The tapered chuck end of the anchor is attached to an air hammer, then after drilling is complete, the tapered end snaps off leaving the anchor flush with the wall. Useful when a large number of anchors are to be installed.

47S: Designed to be inserted into a pre-drilled hole and set into place by means of a setting tool.

47W: Designed to be driven into a pre-drilled hole. The expansion of the case is controlled by the tightening of the nut, this eliminates the need for an exact hole size. Useful in applications where a high resistance to vibratory loads is desired.

 

Concrete Inserts

Figure: 950, 951, 950N, & 951N

Function

Designed to be embedded in concrete to provide a means of suspending pipe from ceilings. The insert is held in place by nailing it to the forms, until the concrete is poured. The insert comes with a snap-out plug to keep the inner housing clean during pouring of the concrete. After the concrete has set, the plug is removed, exposing the inner housing. The Fig. 950N and 951N Concrete Insert Nuts can be installed and the rod fastened to the nut. The rod should touch the inside top of the insert but should not be forced to avoid damaging the insert.

Right Angle Clamp

Figure: 840

Function

Designed for anchoring pipe or conduit at a right angle to structural members.