Search Results for ""

Welding Lugs

Approvals: Complies with Federal Specification A-A-1192A (Type 57) and Manufacturers’ Standardization Society ANSI/MSS SP-58 (Type 57) which supersedes ANSI/MSS SP-69. Ordering: Specify figure number, rod size, material, and finish. View Data Sheet

Concrete Inserts

Approvals: Complies with Federal Specification A-A-1192A (Type 18) and Manufacturers’ Standardization Society ANSI/MSS SP-58 (Type 18) which supersedes ANSI/MSS SP-69. Ordering: Specify figure number. View Data Sheet

Ceiling Flanges

Ordering: Specify figure number, rod size, material, and finish. View Data Sheet

Reversible Side Beam Angle Bracket

Approvals:   Complies with Federal Specification A-A-1192A (Type 34) and Manufacturers’ Standardization Society ANSI/MSS SP-58 (Type 34) which supersedes ANSI/MSS SP-69. Ordering: Specify figure number and finish. View Data Sheet

Side Beam Angle Bracket

Approvals: Complies with Federal Specification A-A-1192A (Type 34) and Manufacturers’ Standardization Society ANSI/MSS SP-58 (Type 34) which supersedes ANSI/MSS SP-69. Ordering: Specify figure number, rod size, material, and finish. View Data Sheet

Turnbuckle

Approvals:   Complies with Federal Specification A-A-1192A (Type 13) and Manufacturers’ Standardization Society ANSI/MSS SP-58 (Type 13) which supersedes ANSI/MSS SP-69. Ordering: Specify figure number, rod size, and finish. NOTE: Openings of 3″  (76.2), 9″  (228.6) and 12″  (304.8) are available upon request. View Data Sheet

Hinged Copper Tubing Extension Split Clamp

Approvals:   Complies with Federal Specification A-A-1192A (Type 12) and Manufacturers’ Standardization Society ANSI/MSS SP-58 (Type 12) which supersedes ANSI/MSS SP-69. Ordering: Specify figure number and pipe size. View Data Sheet

Sway Brace Pipe Attachment

Size: Pipe size 1” (25) thru 6” (150). Install: Place over the pipe to be braced, adjust brace angle, and insert bracing pipe through opening leaving a minimum of 1” (25.4) extending from attachment. Brace pipe can be installed on top or bottom of pipe to be braced but must be a minimum of 6”