Search Results for ""

Multi-Fastener Adapter

Size: 1/2” or 3/4” mounting holes. Braces up to 8” Pipe MAX Install: Attach to the structural surface as noted in NFPA13 fastener tables. Please note that the two outermost bolt holes must be used and the middle bolt hole should be used only in conjunction with both outermost bolt holes to ensure concentric loading.

Sway Brace Bar Joist Adapter

Size: Braces up to 8” Pipe MAX. Attaches to 3/8” thick MAX structural members. When attaching to a structure thicker than 3/8”, please see PHD Manufacturing Fig. 045. Install: Steel bar joist manufacturer’s warranty requires attachment within 6” of chord panel point.  Place on structural member with the flange contacting the back of the jaw.

Sway Brace Pipe Attachment

Size: Pipe size 1” (25) thru 6” (150). Install: Place over the pipe to be braced, adjust brace angle, and insert bracing pipe through opening leaving a minimum of 1” (25.4) extending from attachment. Brace pipe can be installed on top or bottom of pipe to be braced but must be a minimum of 6”

Supporting Pipe Attachment

Size: Pipe sizes 2” thru 8”. Refer to PHD Structural attachment fitting literature regarding appropriate brace members, sizes, and further loading limitations. Install: Attach PHD Manufacturing structural attachment fitting, Fig. 030 (sold separately), to Fig. 040 using supplied fastener.  Place the assembly around the pipe to be braced, positioning welded clevis on top of the

Sway Brace Structural Adapter

Size: Braces up to 8” Pipe MAX. Attaches to 3/8” MINIMUM and 11/4” MAX thick structural members. When attaching to a structure less than 3/8” thick, please see PHD Manufacturing Fig. 035. Install: Place on structural member with the flange contacting the back of the jaw. Tighten set screws finger tight, then evenly tighten until

Clamping Pipe Attachment

Size: Pipe sizes 2” thru 8”. Can use 1” thru 2” SCH 40 pipe, structural steel, and PHD 12 gauge strut channel (1001 & 1201) as sway bracing elements. Install: Place attachment around pipe to be braced, positioning brace attachment as needed, then tighten clamping bolts and nuts finger tight.  Insert brace component into fitting

Large Sway Brace Pipe Attachment

Size: Pipe size 21/2” thru 8”. Install: Place over the pipe to be braced, adjust brace angle, and insert bracing pipe through opening leaving a minimum of 1” extending from attachment. Brace pipe can be installed on top or bottom of pipe to be braced but must be a minimum of 6” away from a

Pipe Slide Assembly

Approvals: Complies with Federal Specifications A-A-1192A (Type 35) and Manufacturers’ Standardization Society ANSI/SP-58 (Type 35). Ordering: Specify figure number, type, finish, and any additional options. Maximum Temperature: 750°F (399°C) PTFE Temperature Range: -20°F to 400°F (-29°C to 204°C) Additional Options: -Extended travels -Extended tee heights -End plates -Clamps -Base plate with mounting holes View Data Sheet

Domestic Beam Clamp

Approvals: Underwriters’ Laboratories Listed in the U.S. (UL), Canada (CUL), for sizes 3/8” to 7/8” only. Factory Mutual Approved for rod sizes 3/8” and 1/2” only. Complies with Federal Specifications A-A-1192A (Type 19) and Manufacturers’ Standardization Society ANSI/MSS SPSP-58 (Type 19) which supersedes ANSI/MSS SP-69. Fig. 353 sized for 3/8” rod can be used in