Search Results for ""

Pipe Saddle Support

Approvals: Complies with Federal Specification A-A-1192A (Type 36) and Manufacturers’ Standardization Society ANSI/MSS SP-58 (Type 36) which supersedes ANSI/MSS SP-69. Ordering: Specify figure number, pipe size, material, and finish. NOTE: Gussets furnished on 8″  (200) and larger. View Data Sheet

Adjustable Pipe Saddle Support

Approvals: Complies with Federal Specification A-A-1192A (Type 38) and Manufacturers’ Standardization Society ANSI/MSS SP-58 (Type 38) which supersedes ANSI/MSS SP-69. Ordering: Specify figure number, pipe size, and finish. NOTE: Gussets furnished on 8″  (200) and larger. View Data Sheet

Pipe Saddle Support With U-Bolt

Approvals: Complies with Federal Specification A-A-1192A (Type 37) and Manufacturers’ Standardization Society ANSI/MSS SP-58 (Type 37) which supersedes ANSI/MSS SP-69. Ordering: Specify figure number, pipe size, material, and finish. NOTE: Gussets furnished on 8″  (200) and larger. View Data Sheet

Adjustable Pipe Saddle Support With U-Bolt

Approvals: Complies with Federal Specification A-A-1192A (Type 38) and Manufacturers’ Standardization Society ANSI/MSS SP-58 (Type 38) which supersedes ANSI/MSS SP-69. Ordering: Specify figure number, pipe size, and finish. NOTE: Gussets furnished on 8″  (200) and larger. View Data Sheet

C-Clamp Structural Attachment

Size: 1/2” mounting hole. Braces up to 8” Pipe MAX Install: Mount device to structure then insert brace element into fitting against back of jaw.  Tighten set screw finger tight, then tighten until hex head breaks off.  Adjust attachment to proper brace angle. Approvals: Underwriters Laboratories listed for US and Canada and Factory Mutual approved.

Offset Bent Tees

Offset Bent Tees

ORDERING: Specify figure number. HOLE DIM: 9/16″ diameter, 13/16″ from end, Fig. 5150, 5155, 5156 & 5160 1-7/8” on centers Fig. 5155 Right Fig. 5156 Left View Data Sheet

Technical Data

General Download Full General Technical Data Material Specifications Finishes Corrosion Channels: American Standard I-Beams: American Standard Wide Flange I-Beams Steel Pipe Data Spacing of Hangers for Steel Pipe Copper Tube Data Spacing of Hangers for Copper Tubing AWWA Ductile Iron Pipe Data Glass Pipe Data PVC Plastic Pipe Data Spacing of Hangers for PVC Plastic

Adjustable Pipe Roller Stand With Base

Sizing: Pipe roller size shown is for bare pipe. For proper sizing with insulation, refer to pipe roller selection guide, which is for use with pipe covering protection saddles. Approvals: Complies with Federal SpecificationA-A-1192A (Type 46) and Manufacturers’ Standardization Society ANSI/MSS SP-58 (Type 46) which supersedes ANSI/MSS SP-69. Ordering: Specify figure number, pipe roller size,